Hanging thumbturn repair GOAL AS.LX

"I can't lock it from the inside, so please check it."

When I checked the target, there was a thumbturn in a dangling state.It is said that he was handed the key today and moved in.

It's clear that the thumbturn's spindle shaft doesn't reach the lock case.I checked and the cylinder has been replaced.But when I took it apart, the pull-leg screws were pretty loose.

I tried reinstalling just the pull-leg, but when I removed the front, the skewer pin was incompletely installed.

The thumbturn unit was fixed with only a screw over the skewer pin.Not piercing units.Moreover, it is only fixed with loose screws.Of course, the shaft will not reach.

However, what a sloppy worker!Certainly he felt a little angry.